Hello,
Probably it is a stupid question, but does anybody have any tips on how to tighten the rear 2 nuts that holds the Solex 35 APAIG on the air intake? For me they are impossible to tighten. See attachment, of course the problem is to tighten them when the air intake is mounted on the engine (unfortunately this is the only pic I have at disposal by now). I hope it is clear enough.
I tried to find on Shop Manual if there are any special tools but I did not find anything (I found many special tools for Weber, but no one for Solex).
Thanks in advance
Carlo
Probably it is a stupid question, but does anybody have any tips on how to tighten the rear 2 nuts that holds the Solex 35 APAIG on the air intake? For me they are impossible to tighten. See attachment, of course the problem is to tighten them when the air intake is mounted on the engine (unfortunately this is the only pic I have at disposal by now). I hope it is clear enough.
I tried to find on Shop Manual if there are any special tools but I did not find anything (I found many special tools for Weber, but no one for Solex).
Thanks in advance
Carlo