Moulding clip wanted

[Tacconi]

Hello
I in a need of some moulding clips for my Giulietta Sprint 750B 1959.
The moulding is in some type of casted aluminium, I also need a the front wing moulding on the right side.
I am missing the door seal holder on the sill who holds the door seal in place.
Hope someone can help med.
Se photos.

[AlfistiSA]

Hi Tacconi

I'm busy investigating a run of the 750 cast aluminium sill mouldings at the moment.

Will keep you informed

Ciao
Greig

[concept 101]

Hi Greig,

While at it and if possible, could you please ask about the later ones (101) in SS as well?

Thanks,
Dennis

[divotandtralee]

Tacconi, "Door seal holder"? Are you speaking of the Aluminum threshold plate? I have the right side. Rick

[Tacconi]

Quote:

Originally Posted by divotandtralee Tacconi, "Door seal holder"? Are you speaking of the Aluminum threshold plate? I have the right side. Rick

[divotandtralee]

Ahem...there is no door seal on the sills. Your friends 2600 might as well be a Buick. There are no door seals on the sills of a Sprint ...over and out.. The door seals are on the door.

[Tacconi]

Quote:

Originally Posted by divotandtralee Ahem...there is no door seal on the sills. Your friends 2600 might as well be a Buick. There are no door seals on the sills of a Sprint ...over and out.. The door seals are on the door.

[divotandtralee]

The only rubber I can remotely consider is a foam gasket that was glued in the crevass/slot between the outer skin and the door jamb. It could have been carried along the step in the threshold. It would be a water trap but a good sound deadener and dust stop, I think it's a nice touch on the vertical but not so on the horizontal. It might make making the door close more difficult. I've never seen it applied there. Rubber suppliers should have a common square-ish profile to work. Rick