Carb Support Identification - Help

**kengta** · #1 (**permalink**) 08-30-2007, 10:55 AM

Photo 1 shows 3 carb support rods that are all about 14-1/2 in long over all. Pics 2, 3, and 4 show details.

I "think" they all are from 105 series 1750's but not sure about the variations.

2 have weld on nuts at top, one does not and it is about 1/8" longer. One, with the nuts, has a clearance detent at the bottom for the starter I think.

Can anyone add clarification as to the applications.

Also does any one know the lengths of the 1600 and 1300 versions. I guessing the 2 litre length to be the same as the 1750.

Ciao

Ken

**kengta** · #2 (**permalink**) 08-30-2007, 11:00 AM

Here are a couple of pics of 2 more supports the I hope someone can ID for me. They are about 13-1/2' long overall.

One has a much smaller bottom end (on left) than the others and no nuts. That might make its effective length center to center longer??
The other has weld on nuts.

Ciao

Ken

**kengta** · #3 (**permalink**) 08-30-2007, 11:09 AM

This one is,I am almost certain, from a GTAj and attaches under the Weber DCOE 45s on the single tud on the carb bottom. I'll will edit when I get a length.

Did the GTAs and/or the GTA Corsa's have a similar but longer support??

Ciao

Ken