Alfasud Sill panels

evanbottcher · #1 (**permalink**) 03-07-2005, 03:38 AM

Hi folks,

I'm looking to get some metal put back in the sills on the Alfasud, and I was wondering if it's possible to get new sill sections to weld in? I see them listed on justsuds.co.uk however the guy doesn't answer his phone. I'm looking for a supplier who can ship the panels to Melbourne, Australia.

Anybody?

thanks,
Evan.

87Sprint · #2 (**permalink**) 03-07-2005, 04:49 PM

Quote:

Originally Posted by evanbottcher

Hi folks,

I'm looking to get some metal put back in the sills on the Alfasud, and I was wondering if it's possible to get new sill sections to weld in? I see them listed on justsuds.co.uk however the guy doesn't answer his phone. I'm looking for a supplier who can ship the panels to Melbourne, Australia.

Anybody?

thanks,
Evan.

arguti · #3 (**permalink**) 04-05-2005, 06:52 AM

Evan

The guy from justsuds does eventually respond. best is to try him on his cell and then he he calls you back whne he is in the office.

managed to get new sprint sills off him recently as well as wheel arch repair bits.
new sud front fender on ebay on http://cgi.ebay.co.uk/ws/eBayISAPI.d...540150229&rd=1

Stephen

genius · #4 (**permalink**) 04-05-2005, 07:21 AM

Evan...

which Sud do you have...I'll have a hunt, there should be something on this side of the ditch !

evanbottcher · #5 (**permalink**) 04-05-2005, 05:32 PM

Thanks - I'm handing the Sud to a panel guy next week, he says he'll get some sills bent up and the cost is ... well not quite extortionate. I looked at getting some sills in from the UK, but it's hard to judge the quality/fit of what you are buying and shipping expensive.

Appreciate your offer though!

cheers,
Evan.