[sprintgtc]

Step 4: Body reshaping:
There are two areas on each nacelle that require modification. The bare metal area in the picture below shows where adjustment is needed. The outer contour needs to be about ½ inch higher and have a more defined edge. The inner contour is pretty close but needs adjustment near the headlamp. This isn’t hard if you have some experience with bodywork and Bondo, but it probably is not a project for the first timer. You will need to check progress against the shape of the headlight cover. Be careful not to damage them. I use a product called All-Metal to get the rough shape. Then finer fillers are used to smooth and blend.