[Alfisto Steve]

Starter the same but also has a front mount similiar to Milano and GTV6 so even harder to get out than 12v 164.

If cigarette seals leaking you have to pull oil pan to replace. Remove lower front steel bell housing cover from over flywheel so you can see better where oil leaking from first. Cover between front exhaust pipe and flywheel. Has 3 10mm hex bolts holding it on. Spray clean area and check for leak. Also check rear edge pan bolts for looseness.

Hopefully it is not cigarette seals.

As for 2-step flywheel outer flat surface machined lower for mounting pressure plate than inner surface for clutch disc to mate with.

Machinist needs to measure depth first so he takes off same amount from both surfaces to keep the same difference after machining inner surface.