|
Rear main oil seal
I would like to replace the rear main oil seal on a '95 164Q. Leaking oil burning on the exhast pipe under the bellhousing is poisoning me as I drive and leaving an oily patch on the driveway. I've read a few of the posts on this subject but would like to make sure I understand the job and parts needed before starting. Is this list correct?
Parts:
1) Rear main oil seal
2) Clutch (82K miles on the existing one which works fine)
3) Pressure plate?
4) Throw out bearing?? (works fine)
5) Starter??? (works fine)
6) What else?
Things to do:
1) Resurface flywheel? What is the two step resurface I've read about?
2) Check transmission input shaft for roller vs. ball bearings
3) Cigarette seals, any chance these are the leak problem?
4) What else?
Terry Manchester
Los Gatos, CA
'64 Giulia Spider
'74 GTV
'95 164Q
|