....up date time?
...you may recall that I obtained from parts car a replacement front diaphragm panel only to find out later that there was more rust on it than I had hoped. As a result I had to disassemble the entire assembly, cut out the rusty bits and fabricate new ones as well. This is the upper cross piece that was made from a former that I fab'd up.
..I formed the Z section first..clamped the former to the lower flange and formed a return flange and lip on the bottom edge..
...former made similair to the other one I posted previously....this time I attached a flat aluminum piece to the square section using countersunk screws....aluminum is real easy to work with and this took no time at all...
