Phil,
Here's a link to the engine dolly project:
http://www.alfabb.com/bb/forums/car-restoration/9049-engine-tranny-stand.html
I did not do any drawings, just bought a bunch of 2"x2" metal
square tubes and used a chop saw, and measured as I went
along. Worked out pretty good, althought I should have
used larger plates where the motor mounts go, cause my
engine cannot be bolted onto the dolly. But it's nice to
have to move the motor around the shop.
Dan,
I think I have found some studs, but thanks for the offer.