|
A couple of more thoughts . .
1. Maybe a dremel tool with a cutter burr
Or even better and faster . . . . .
2. Set the assembly in a vice, flange side up. Take your trusty saber saw and trim a metal cutting blade (or shim the top of the assembly) so that it's the correct depth is reached at the bottom of the stroke, then very carefully cut down through the bushing metal at two places, but not into the holder. Use a broken off hacksaw blade by hand to cut through the last few micros of metal before you hit the holder. Should pop out easily after that.
__________________
John Stewart
74 Spider
Last edited by Roadtrip; 11-10-2003 at 08:11 PM.
|