|
You can replace the cable. I purchased a spool of cable at Granger. I used the old one to measure the new one. I used the cremp on electrical connector end pieces to create the ends . They pinch on after the cable is fed through the spool. Of course you cut off the actual electrical connector and just use the cremping part. It is so frustrating to try to put a bent cable back on the pully system. It will drive you nuts. I use cable ties to hold the cable on the spool while putting the winder back in the car. Once I get all but the last pulley on, I cut the ties and fit the last pulley. Cranking down on the adjuster at the bottom. There is also one slideing pulley at the top.
|